[ Chinese | English ]  
Home About Reach News Products Contact us   Add To Wishlist
  Rubber Chemicals And Additives
  Rubber Release Agent
  Tire Auxiliary Products
  High Dispersion Colloidal Particle
  Rubber Compound
  Rubber Raw Materials
  Carbon Black
  Rubber Processing Auxiliary Products
  Products Your present position:REACHTIRE INDUSTRIAL CO.,LTD > Products
Previous: Batch-off release agent PRP-75C Mould release agent TM-80CT2 Next: Hoses Release Agent HMK-65A


  TM-80CT2 is water based semi-permanent release agent which contains special active polymers. It can form a thin, uniform coating film on the surface of the mould, and the film has a good adhesion to the surface of metallic mould. Due to the film’s higher compactness and lower surface energy, it can reduce the adhesion between the rubber and the mould, prevent rubber vulcanizates from sticking to the molds and facilitate the release from the molds, and thereby improve the quality of product appearance; TM-80CT2 product can give a release effect for several demoldings and also reduce the cleaning frequency of the mould. 

Application fields

  TM-80CT2 can be used in the production process of all kinds of rubber except Silicone rubber. It is suitable for all articles that are formed by injection molding or compression molding.


  At the first time, the mould should be clean before using TM-80CT2, and then spray TM-80CT2 two or three times onto the hot mould carefully. After that, a short drying / curing time is necessary to accelerate the film formation, longer drying time and higher curing temperature will get an durable release film and effective performance with more demoulding times. Normal vulcanization process can be performed if the pretreatment above were completed. The latter vulcanization process just need spray TM-80CT2 one time in certain intervals and dry for a short time.  The number of demoldings that can be achieved with one coat is very much dependent on the particular conditions
and has to be investigated in every single application. It is advisable to apply TM-80CT2 on to the surface of the mold by means of a spray gun. 

Technical Data

  Composition:  water based resin emulsion without any solvent.
  Appearance:   white emulsion.
  pH:  4~7; 


 25kg plastic drum, 50kg plastic drum.

Safety and Transport

  TM-80CT2 is not classified as a dangerous good according to transport legislation, so it can be transported in terms of non-dangerous goods. The product has no any hurt if you use it in right way. Consult material safety data sheet (MSDS) for additional handling information on TM-80CT2.


  TM-80CT2 should be stored in cool and dry place with closed container, protected from frost, heat and direct sunlight. Under the above conditions, the product has a shelf life of 6 months at least. 

Further information

  Product technical information and data is based on the best information available and does not constitute or imply a warranty or patent infringement of any kind. The user is responsible for testing product suitability before to use the production.

Qingdao,Shandong,China Tel: 0086-532-67773206